He has more than 40 years of experience in the consumer product manufacturing. This article was prepared for you by SK Wong from Malaysia and he graduated from London with a degree in Electronics and Electrical Engineering. After a few soldering attempts I managed to re-soldered it. After carefully removed the IC without damaging the board, I have a hard time trying to re-align the position of the new IC as the solder pads are underneath and difficult to view from the edges. The back of the IC is soldered to the board as well which make it more difficult to remove. Tips: Reworking manually on IC18 is not an easy task due to the QFP packaging being small, thin and leadless. By reducing the sub-contrast level and the RGB gain by a certain value in the service mode, the vertical lines are not visible and the reduction in gain and contrast level have not change the video quality significantly as shown below. The customer is very happy and satisfied with the end result as the repair cost does not burnt a hole in his pocket. Changing the main board will be ideal but may not be worthwhile as the main board is not cheap. ![]() As I have suspected earlier the main board is also contributing to the problem. After changing the this IC there is a remarkable improvement on the video quality except for some fine vertical lines still visible only at high contrast level. The gamma IC on the T-con board is IC18 with part no. I suspected the gamma IC is faulty although it displayed no gamma distortion. The intensity of the vertical lines changes with the contrast level as well. There is no gamma distortion or noise on the grey scale but RGB vertical lines are being superimposed on it (see photo 1). I performed a grey scale test with the same procedure as in my earlier article on gamma distortion. The possible cause could be the main board, T-con board or both. Since the vertical lines are not in the static location and always changing with the video display so, it is unlikely the LCD panel is at fault. ![]() The intensity of the vertical lines changes with the RGB signals and very prominent on white video signal as shown below: I received this defective Samsung model: LA40A650AIRXX which has vertical lines superimposed on to the video signal.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |